BNMGP - COVERS OVER TAN
- MSDS: BNMGP
- Manufacturer: IDEAL STENCIL MACHINE AND TAPE CO
- Product Name: COVERS OVER TAN
- National Stock Number: 8010-00N028020
Product Identification
Product ID:COVERS OVER TAN
MSDS Date:05/22/1991
FSC:8010
NIIN:00N028020
MSDS Number: BNMGP
Responsible Party
BELLEVILLE, IL 62222-0305
US
Emergency Phone: 618-233-0162; 618-325-1821
Info Phone: 618-233-0162
Preparer: S. BOYD
Cage: 30133
Contractor
Telephone: 618-233-0162
Cage: 30133
Ingredients
ETHYLENE GLYCOL
CAS: 107-21-1
RTECS: KW2975000
Fraction By Weight: 5%
OSHA PEL 50 PPM, C
ACGIH TLV: 50 PPM, C
EPA Report Quantity: 1 LB
DOT Report Quantity: 1 LB
ACRYLIC ACID, POLYMERS; (ACRYLIC POLYMER)
CAS: 9003-01-4
RTECS: AT4680000
Fraction By Weight: 20%
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE:EYES:MAY CAUSE SLIGHT
IRRITATION. INGEST:MAY CAUSE NAUSEA, VOMITING.
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.
First Aid
First Aid:EYES:IMMED FLUSH W/WATER FOR AT LEAST 15 MINUTES. CALL MD.
SKIN:FLUSH W/WATER. INGEST:CALL MD. IF ANY OTHER HARMFUL EFTS ARE
SUSPECTED, MD SHOULD BE CALLED PROMPTLY TO DETERMINE NECESSITY FOR
TREATMEN T OR OTHER TESTING. INHAL:REMOVE TO FRESH AIR. SUPPORT
BREATHING (GIVE O*2/ARTF RESP) .
Fire Fighting
Flash Point Method:TCC
Flash Point:>250F,>121C
Extinguishing Media:WATER, DRY CHEMICAL, FOAM.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA & FULL
PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:NONE
Accidental Release
Spill Release Procedures:DIKE & CONTAIN SPILL W/INERT MATERIAL.
TRANSFER LIQUID TO CONTAINER FOR RECOVERY OR DISPOSAL. FLOOR MAY BE
SLIPPERY, CARE SHOULD BE EXERCISED TO AVOID FALLS.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:SPRAY FROM PRODUCT MUST NOT BE
INHALED.
Other Precautions:RESIDUAL MONOMERS CONTENT UNDER CNDTNS OF NORM HNDLG
& USE DOES NOT PRESENT HAZ. HOWEVER, MONOMER VAPS CAN BE RELS INTO
WORKROOM ATM WHEN EMULSIONS ARE HEAT CURED/DRIED (ROLLERS OVENS,
INFRARED LAMP & COMPARABLE EQUIP) IF GOOD VENT (SUPDAT)
Exposure Controls
Respiratory Protection:NONE REQD IF GOOD VENT IS MAINT. OTHERWISE WEAR
NIOSH/MSHA APPRVD RESP SUITABLE FOR VAP/MIST CONCS ENCOUNTERED.
NIOSH/MSHA APPRVD RESPS SHOULD BE PROVIDED IF ENGINEERING CTLS ARE
NOT ADEQ. INHAL EXPOS TO MISTS OF PROD SHOULD BE (SUPDAT)
Ventilation:MECHANICAL LOCAL EXHAUST AT POINT OF CONTAMINANT (VAP/MIST)
RELEASE.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:NONE SPECIFIED BY MANUFACTURER.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
OTHER PREC:IS NOT USED. RESP PROT:MAINTAINED BELOW 10 MG/M3.
Chemical Properties
HCC:N1
Boiling Pt:B.P. Text:215F,102C
Vapor Density:HVR/AIR
Spec Gravity:1.46
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:TAN LIQUID.
Percent Volatiles by Volume:0
Stability
Stability Indicator/Materials to Avoid:YES
AVOID STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:NONE SPECIFIED BY MANUFACTURER.
Disposal
Waste Disposal Methods:DISPOSAL MUST BE I/A/W FEDERAL, STATE & LOCAL
REGULATIONS .
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.